Intermediate Handle Assembly Kit (2303-0347KIT) Instructions
Preparation: |
- Shut water supply to the faucet off: Important: Turn off the water supply at the faucet before starting. You can either turn off the main supply to the house or close the shut-off valves if the faucet is equipped with them. Then open the faucet again to empty it of residual water. Failure to do so could result in flooding or injury.
Tools: |
- Small flat head screwdriver
Instructions: |
 |
 |
|
Remove center cap from handle. Rotate brass screw counterclockwise from handle and remove along with washer. Pull off handle from bell housing. |
 |
Pull off bell housing from trim. Pull brass hot limit stop from intermediate handle assembly and set aside. Remove existing intermediate handle assembly by rotating the screws on the right and left, counterclockwise.
|
 |
|
Replace intermediate handle assembly. Replace screws; rotate counterclockwise to tighten. Slide the brass hot limit stop onto the intermediate handle assembly, with the brass peg to the right of the plastic stop. |
|
Insert round black spacer into the underside of the bell housing and push into place. |
 |
Replace bell housing onto trim and replace the handle at the 6 o’clock position, spline side down. |
 |
|
Replace brass washer and screw into the handle and tighten clockwise. |
 |
Replace center cap. |
 |
|
|
