5 HOLE INSTALL KIT: Instructions with Country Bath Tub Filler
5 HOLE INSTALL KIT Instructions with Country Bath Tub Filler 8.29.14.pdf
5HOLEINSTALLKIT
Diverter Installation with Country Bath 3 Hole Tub Fillers
Please note: When converting a 3 hole tub filler to a 5 hole tub filler, additional parts are needed.
You must order part # 5HOLEINSTALLKIT to complete the installation.
Shut water supply to the faucet off: Important: Turn off the water supply at the faucet before starting. You can either turn off the main supply to the house or close the shut-off valves if the faucet is equipped with them. Then open the faucet again to empty it of residual water. Failure to do so could result in flooding or injury.
 |
5HOLEINSTALLKIT consists of the following parts:
|
|
Diverter Assembly: Please note: BV216 diverter may have an extra port that is plugged from the factory. |
 |
|
|
Remove the two brass adaptors from the diverter and install the adaptors provided with the trim, |
 |
 |
Assemble the LFA-858 T-fitting with LFA-77 nipples and install the LFA-858 T-fitting on the bottom of the BV216 diverter, using Teflon tape on all connections to create a seal.
Install the flex hoses from the side valves of faucet to the inlets on the LFA-858 T-connection. Use flat washers to make a seal.
|
Spout Assembly:
Remove the 1/2” cap at the end of the spout assembly and remove the 3/4” T- connection from the bottom of the faucet. |
|
Replace the 3/4” T-connection with the C7432 Banjo connector Install the C7437 1/2” cap nuts on the new C7432 Banjo connector with flat washers. Tighten assembly. The C7432 Banjo connector will act as a spacer. |
Install the U.5379 1/2” female to 3/4” male adaptor on the bottom outlet of the spout. Use Teflon tape to make a seal. Install the C7089.6034NSF 3/4” hose to the U.5379 adaptor on the spout assembly. Use Teflon tape to make a seal. |
|
Assembly Complete:
|
Install the other end of the C7089.6034NSF 3/4” hose onto the outlet on the BV216 diverter valve. |
 |