Skip to main content
House of Rohl Solutions

1090-00 Installation Instructions

 
Please take a few minutes to review these instructions before you start the installation. If you encounter any installation or performance problem, please do not hesitate to contact ROHL at 1-800-777-9762. www.rohlhome.com

Before you Begin:

CAUTION: Risk of personal injury. Wear appropriate safety equipment when installing this lavatory sink.

  • Observe all local plumbing and building codes.
  • These instructions are for installing the lavatory to wood frame construction.
  • The wall and floor must be square, plumb and level.
  • Location of angle stops should be positioned below the faucet for ease of installation of decorative angle stops and rigid risers.
  • Use lag bolts (not supplied)
  • Use hangers (not suppled)

Please note: Sink must be installed into a reinforced wall. If the position of the installation does not mount directly unto studs, a wooden blocking must be installed between two studs to support the weight of the installation.

Tools Required:
  • Square
  • Tape Measure
  • Pliers   
  • Drill with screwdriver attachment 
  • Level 
  • Pencil
Install the Lavatory:
Please note: Sink must be installed into a reinforced wall. If the position of the installation does not mount directly unto studs, a wooden blocking must be installed between two studs to support the weight of the installation.
  • Determine desired height. Place the sink against the wall and level off. CAUTION To reduce risk of personal injury and product damage: Support the lavatory sink during installation. The mounting slots alone cannot support the lavatory sink.
  • With a pencil, mark locations of right and left lag bolt slots and hanger slates.
  • Remove sink from wall. It is recommended the faucet and pop-up drain assembly be prefixed to the sink, following manufacturer’s instructions, prior to final mounting.
  • Drill for lag bolts (not supplied) into studs, or reinforced wooden blocking, and install hangers (not supplied); adjust as necessary.
  • Mount sink; adjust as needed. Tighten lag bolts. CAUTION: Risk of product damage. Do not over tighten the hardware. Over tightening may damage the lavatory sink or finished wall. Avoid scratching the finish.
  • Install P-trap and faucet supply lines accordingly.
 

Contact Us:

Canadian ConsumersEmail or Call 1-866-473-8442

U.S. ConsumersEmail or Call 1-800-777-9762

clipboard_e35e95fe6b353992dfd29318b4e5da607.png

  • Was this article helpful?