9.07840 Seal Kit
Changing the 9.07840 Seal Kit for the Perrin & Rowe ® C-Spout kitchen faucets
Tools Required:A small flathead screwdriver or a 2MM Allen key Skill Level/Time:Easy. About 15 minutes Preparation:Shut water supply to the faucet off: Important: Turn off the water supply at the faucet before starting. You can either turn off the main supply to the house or close the shut-off valves if the faucet is equipped with them. Then open the faucet again to empty it of residual water. Failure to do so could result in flooding or injury. |
 |
|
Spouts with diverters will use the large and medium O-rings. (U.4702 & U.4719 spouts pictured) |
Spouts without diverters will use the large and small O-rings. (U.4790 spout pictured)
|
|
Locate the set screw in the back of the spout base. Using either a flathead screwdriver or a 2MM Allen key, unscrew by rotating counterclockwise. Pull up on the spout and replace the seals with the correct ones needed for your style spout following the adjacent photos here. Replace spout back into faucet by lining up the cut or small hole with the hole in the base of faucet and tighten the set screw by rotating clockwise. Do not over tighten. |
|
 |