R7903 Side Lever Pull-Out Handle Replacement Instructions
Tools Needed: 5/64” Allen wrench, small crescent wrench
Shut water supply to the faucet off: Important: Turn off the water supply at the faucet before starting. You can either turn off the main supply to the house or close the shut-off valves if the faucet is equipped with them. Then open the faucet again to empty it of residual water. Failure to do so could result in flooding or injury.
 |
Using the crescent wrench, loosen the lever bolt by gently rotating counterclockwise. Be sure not to damage the finish. Once the lever bolt is loosened, continue rotating counterclockwise by hand. |
 |
Remove the lever bolt, lever insert, and lever spacer. |
 |
Using the 5/64” Allen wrench, insert into the hole on the handle dome and rotate the set screw counterclockwise until loose. |
 |
Pull out the set screw from the handle dome. Pull off the handle dome from the cartridge by hand. Replace the handle dome if applicable. |
 |
Ensure the black plastic insert is installed correctly; the grooved side with the hole should be aligned with the hole in the handle dome (red outline shows groove). |
|
Follow the instructions in reverse to reinstall the handle assembly. |
|
|
|
