Pop-Up Drain Instructions

PROBLEM: ON INITIAL INSTALLATION THE POP-UP SEEMS TO LEAK WATER IN THE DOWN POSITION

SOLUTION:

1. TILE POP-UP HAS NOT BEEN INSTALLED PROPERLY-THAT IS- PLUMBERS PUTTY  HAS NOT BEEN USED TO MAKE THE CORRECT SEAL IN THE SINK
2. THE SINK MAYBE CRACKED, BUT THIS IS VERY RARE

Assembly:

Remove the parts from the package.

1. Apply a thick application of Plumbers Putty (not supplied in the package, but must be supplied by installer) to the rim of the escutcheon.

2. Insert the escutcheon in the drain opening (discard the foam ring).

3. Stack the:

a. Large conical rubber piece on the bottom of the drain first- push to the top

b. Then the white nylon friction washer.

c. Then the nut.

4. Tighten the nut, holding the drain straight in the drain hole

a. This will compact the plumbers putty making a watertight seal

5. Screw the horizontal pop-up assembly onto the bottom of the drain

a. Make sure the clear nylon ring is on the top assembly next to the drain threads

6. Screw on the bottom drain pipe

a. Use Teflon tape on the threads to avoid leaking

7. Make your P-trap connection

8. Remove the excess plumbers putty from the bowl

9. Insert the pop-up

a. As you insert the pop-up, unscrew the horizontal pop-up rod, and put the rod end into the nylon pop-up hole.

b. Screw the nut back on. Note: Do not over tighten, this will cause the pop-up rod to move very hard