Skip to main content
House of Rohl Solutions

HRK-2000 Connecting to the faucet threaded mounting rod

This article will explain how to resolve issues connecting the HRK-2000 to filtration faucets with a threaded mounting rod
Preparation

Tools required:

  • Pipe-cutter, 
  • Medium 120-grit sandpaper

Shut water supply to the faucet off: Important: Turn off the water supply to the faucet before starting. You can either turn off the main supply to the house or close the shut-off valves if the faucet is equipped with them. Then open the faucet again to empty it of residual water. Failure to do so could result in flooding or injury. 

Legend
clipboard_e3cf2edad9105b40d20919627e24d83ff.png

A: HRK-2000 Flex hose 1/4" tube 

B: HRK-2000 Compression Nut

C: HRK-2000 Compression Olive Sleeve

D: Faucet Mounting Threaded Rod

Explanation

This is a solution provided to connect the HRK-2000 to a filtration faucet threaded rod if you cannot use the filtration system push fit connectors. This will connect the filtration flex hose directly into the threaded rod and it requires the Flex Hose 1/4" tube to be cut.

clipboard_e08ad803a7b98bc6fc9d5c569586afc88.png

The end of the HRK-2000 Flex hose tube (indicated by the red arrow) is about .25mm larger than the middle of the tube.

clipboard_e22e6ca17001858fdd91048618bf860d3.png

For that reason, the tube, if not cut, will not fit in the faucet threaded mounting rod as shown above. 

Instructions

Step 1:

clipboard_ef6fd300813c1fd8be9fb55743e10e94b.png

Slide off the compression Olive sleeve and nut from the HRK-2000 flex hose tube.

Step 2:

clipboard_e07c77458eb794b24b83429dceabe0824.png

With a pipe cutter or similar tool, cut the larger end tip of the tube. **Make sure you don't cut too much, as you need to leave enough tube length to be able to reinstall the Compression Nut and Olive Sleeve.  

Step 3:

clipboard_ee8ee5c2b82a6e7aa7d2fea6fc2d9f934.png

The cut must be square to prevent leaks. Use sandpaper to file pipe edges.

Step 4:

clipboard_e97c97b726fc87ac183ad99b5a58e0853.png

Test it to make sure the cut-off tube fits into the Faucet Mounting Threaded rod. 

Step 5: 

clipboard_ea38339eb4fe57c197bdce914a5f17f1e.png

Assemble by sliding the Compression Nut first on the cut tube, followed by the Compression Olive Sleeve. Tighten the Compression Nut to make a seal and test for leaks.

 

Contact Us:

Canadian ConsumersEmail or Call 1-866-473-8442

U.S. Consumers: Email or Call 1-800-777-9762