Five Hole Install Kit - Instructions with Country Bath Tub Filler
BV216 5HOLEINSTALLKIT Instructions with Counrty Bath Tub Filler.pdf
|
BV216/5HOLEINSTALLKIT Diverter Installation with Country Bath 3 Hole Tub Fillers Please note: When converting a 3 hole tub filler to a 5 hole tub filler, additional parts are needed. You must order part # 5HOLEINSTALLKIT to complete the installation. Shut water supply to the faucet off: Important: Turn off the water supply at the faucet before starting. You can either turn off the main supply to the house or close the shut-off valves if the faucet is equipped with them. Then open the faucet again to empty it of residual water. Failure to do so could result in flooding or injury. |
 |
Tools Required:Adjustable wrench, Teflon tape Preparation:Turn Water Supply off before repair Consists of the following parts:Qty 1 U.5379* Qty 2 C7437 Qty 1 C7432 Qty 1 C7089.6034 NSF Qty 2 LFA-77 Qty 1 LFA-858 |
Diverter Assembly: Please note: BV216 diverter may have an extra port that is plugged from the factory. |
 |
Please note: When installing the BV216 diverter into deck, do not discard the white or black handle guide. The guide stops the handle from rotating 360 degrees.
|
|
Remove the brass adaptors and install the adaptors provided with the trim. Assemble the LFA-858 T-fitting with LFA-77 nipples and install the LFA-858 T-fitting on the bottom of the BV216 diverter, using Teflon tape on all connections to create a seal. Install the flex hoses from the side valves of faucet to the inlets on the LFA-858 T-connection. Use flat washers to make a seal. |
Spout Assembly: |
 |
| Remove the ½” cap at the end of the spout assembly and remove the ¾” T- connection from the bottom of the faucet. |
 |
 |
|
Replace the ¾” T-connection with the C7432 Banjo connector. Install the C7437 ½” cap nuts on the new C7432 Banjo connector with flat washers. Tighten assembly. The C7432 Banjo connector will act as a spacer. |
 |
|
Install the U.5379 ½” female to ¾” male adaptor on the bottom outlet of the spout. Use Teflon tape to make a seal. Install the C7089.6034NSF ¾” hose to the U.5379 adaptor on the spout assembly. Use Teflon tape to make a seal. |
Assembly Complete: |
 |
| Install the other end of the C7089.6034NSF ¾” hose onto the outlet on the BV216 diverter valve. |
 |