CU720, LV720, AC720 and WA720: Trim stacking issues
Image of incorrect sequence of installation |
In this above picture, the brass ring was put on first and pushes the other parts far out. This is incorrect. Follow instructions below for proper trim installation sequence.
Preparation |
- Always shut off the main water supply to valve before servicing
Legend |
 |
|
Instructions |
Step 1
The Tall Finish Ring (1) has inner threads at the bottom. Screw it on the rough valve (4) first all the way down until it stops. |
Step 2
Screw the Small Finish Ring (3) into the Brass Ring (2) inner threads. It will go in only one way. |
Step 3
This is how the Brass Ring/Small Finish Ring assembly looks like. |
|
Step 4
Slide the faceplate around the Tall Finish Ring (1), then insert the Brass Ring/Small finish Ring assembly inside the Tall Finish Ring (1) hole and screw it on the remaining outer threads of the rough valve body. This will hold the faceplate in place. |
Step 5
When screwed all the way down, there will be about 1" of the Tall Finish Ring sticking out. |
Additional information
Minimum from the back of the valve to the faceplate is about 3-1/4" |
|
 |