Assembly:
- Remove the parts from the package.
- Apply a thick application of Plumbers Putty (not supplied in the package, but must be supplied by installer) to the rim of the escutcheon.
- Insert the escutcheon in the drain opening (discard the foam ring).
- Stack the:
- Large conical rubber piece on the bottom of the drain first- push to the top
- Then the white nylon friction washer.
- Then the nut.
- Tighten the nut, holding the drain straight in the drain hole
- This will compact the plumbers putty making a watertight seal
- Screw the horizontal pop-up assembly onto the bottom of the drain
- Make sure the clear nylon ring is on the top assembly next to the drain threads
- Screw on the bottom drain pipe
- Use Teflon tape on the threads to avoid leaking
- Make your P-trap connection
- Remove the excess plumbers putty from the bowl
- Insert the pop-up
- As you insert the pop-up, unscrew the horizontal pop-up rod, and put the rod end into the nylon pop-up hole.
- Screw the nut back on. Note: Do not over tighten, this will cause the pop-up rod to move very hard
|
 |