C1458SPECKIT Instructions
Tools needed: 2MM Allen key, small crescent wrench, needle nose pliers, long flat head screw driver
Shut water supply to the faucet off: Important: Turn off the water supply at the faucet before starting. You can either turn off the main supply to the house or close the shut-off valves if the faucet is equipped with them. Then open the faucet again to empty it of residual water. Failure to do so could result in flooding or injury.
Using a 2MM Allen key rotate the set screw at the back of the bridge, counterclockwise. Once loose, pull the spout up and off of the bridge.
|
Using needle nose pliers, stick one end of the pliers against the plastic housing of the diverter, caulk to the side for leverage, and pull the diverter straight up and out of the faucet. Grease the replacement diverter liberally and install. |
Reinstall the spout, aligning the break in the top rigid clip with the set screw hole at the back of the bridge and seat spout into place Using a 2MM Allen key rotate the set screw clockwise to tighten.
|
Unscrew the aerator at the end of the spout by rotating counterclockwise. Remove existing aerator and o-ring and replace with the new high flow aerator and o-ring.
|
Sidesprayer |
![]() |
![]() |
![]() |
Using a small crescent wrench, remove the side spray hose off of the side spray handle by rotating counter clockwise.
By hand, unscrew the head of the side spray off of the handle.
Using needle nose pliers pull the inner white plastic tube up and out of the side spray handle.
Using a long flat head screw driver push the existing flow restrictors out from the bottom side of the side spray handle through the top side of the side spray handle.
Insert the new flow restrictors into the top side of the side spray handle and push through to the bottom.
Insert the white plastic tube back into the side spray handle and push down until it seats.
Screw the head of the side spray back on, rotating clockwise until tight.
Test.
![]() |