9.13841 Cartridge Instructions

Last updated
Save as PDF

9.13841 Cartridge Replacement Instructions

Tools Required:

15" Cresent Wrench 4mm Allen key, Thermometer

Preparation:

Shut water supply to the faucet off: Important: Turn off the water supply at the faucet before starting. You can either turn off the main supply to the house or close the shut-off valves if the faucet is equipped with them. Then open the faucet again to empty it of residual water. Failure to do so could result in flooding or injury.

The action on the Control Cartridge:
Push in to turn on
Pull out to turn off
This is the opposite of most side lever faucets in the
market place.
To change the cartridge:
   Tools needed:
       15" Crescent Wrench
       4 mm Allen Wrench
1) Turn the water off to your faucet
2) Unscrew lever bolt 9.24745 and insert 9.26760
3) Remove the brass insert with a 4mm Allen Wrench from
the ball assembly 9.01340
4) Unscrew the finished dome cover 9.12745
5) Remove the ball assembly 9.01340 from the cartridge
stem (if it is difficult to remove, thread the lever bolt
back on for added leverage)
6) Remove the cartridge nut with the 15" Crescent Wrench
7) Pull out the old cartridge 9.13841, check and clean the
chamber of any debris
8) Insert the new cartridge and follow steps 1-6 in reverse to
reassemble the faucet

9.21427 Hand Spray Servicing Instructions

The action of the hand spray:
Depress the button on the back of the spray head, when the faucet is on to engage the spray.
Release the button to disengage the sprayer and the water will return to the spout. If water
continues to drip/leak from the spray more than 1-2 minutes after disengaging it, follow the
instructions below to service/repair your hand spray.

To service or repair the spray:
   Tools needed:
       6" Crescent Wrench
       1 Paper Towel
1) Lay a paper towel out across the counter top, all work
should be done over the paper towel
1) Unscrew the spray 9.27776 from the hose 9.28426
2) Unscrew the spray head from the handle
3) Remove the long plastic tube from the handle
4) Using the 6" crescent unscrew the large front nut and
small back nut on the spray head
5) Push the cartridge out of the head
   a) If you are only servicing the spray: disassemble, clean, and re-grease the plastic components
   b) If you are repairing the spray: replace all the
   components included in the 9.21427 service kit
6) Reassemble the spray by following steps 1-5 in reverse order

Contact Us:

Canadian Consumers: Email or Call 1-866-473-8442

U.S. Consumers: Email or Call 1-800-777-9762