Salome-Zendo open spout - cleaning or replacing the flow reducer
|
This article explains how to clean and remove the flow reducer in the Salome and Zendo open spout single holes models, when you have low flow issue. |
Preparation: |
Important: Turn off the water supply at the faucet before starting. You can either turn off the main supply to the house or close the shut-off valves if the faucet is equipped with them. Then open the faucet again to empty it of residual water. Failure to do so could result in flooding or injury.
- Recommended tools: 2.5mm allen key, long-nose pliers, wood screw (to be used if necessary to remove the flow reducer, see step 6).
Instructions: |
|
These instructions show how to remove the handle of a single-hole faucet from the Salomé collection. If this is not your faucet model and you don't have your faucet part's page to guide you, please visit https://fr.houseofrohl.ca/ or contact us. |
|
Additional information: If in step 6 you cannot remove the flow restrictor with the pliers, you can screw a wood screw in and pull it out. Note that it will then be broken and you will not be able to reuse it. If you need to install a new flow reducer, insert it so that you can see the o-ring once it is in. Important: You must have a flow reducer in an open spout faucet, otherwise water will be sprayed over the sink. |
|
SA01, SL01, SA14 |
SA11 |
ZOOP11 |
 |
 |
 |
|
|
|
Clean or replace (A). Follow the steps in reverse to install the flow reducer |
|
|
